Repair Washing Machine By Yourself

If you have a problem in fixing the washing machine, no need to call a repairman, why not try to solve alone? Most problems that occur in your washers are actually quite common and can be easily solved. Do you really need to spend much money to call a repair man to come and solve the problem.

Precautions

Before you start repairing a washing machine, make sure the washer is unplugged first. Some people believe that a small problem could be solved without unplugging the machine, but any problems, you should throw in the towel. This is mainly due to security reasons. And why not disconnect if it only takes a few seconds?

Tips for buying parts for the repair of a broken washing machine

Before you dispose of your old washing road, keep in mind that the washing machine is broken and later in time to come, you may need some spare parts to fix the problem like this. Therefore, you should check your old drive washing machine, before disposing of and dismantle the parts you need. Buying from a dealer to repair the washing machine is not a good idea because it would also buy recycled parts used in washing machines. A better solution is to check with an appliance parts wholesalers where you can get new and even cheaper, washing machine parts.

Spinning or agitating Disorders

If the agitator washing machine does not work, do not worry. Compared to other parts of the washing machine agitators are relatively easier to solve. The belt is the labor agitator, and if the belt if you lose, it could cause unrest in the washing machine to malfunction. To see the belt agitator, remove the back panel of the washing machine. Find and belt press. If the car moves about 1 / 4 inch, all you have to do is tighten. If you see the drive belt is damaged, it is time to buy a new one.

In close a belt drive, all you have to do is relax a little nut assembly on the engine and its engine facility in railways mountain. Wait until the band is perfectly tight and before mounting nut. Last step is to return the access panel and the washing machine is fixed.

Leaking Washing

If you have a washing machine that leaks, and it is very likely that the leak comes from the tube. To solve these problems washing machine, check the tubes, while the washer fills. If you find that the loss of the source, all you have to do is squeeze the tube.

Rips or tears in the material

If you see cracks or tears in the washing machine may come from the tub or agitator. Some washers tub is made of plastic and has sufficient resistance to corrosion. Unfortunately, the holes in these tanks rust in May. If you want to check if there are difficult moments in your bathtub, just an old nylon glued to your hand and go to the bath. If there is a place that tears the clothes during washing, and then find the sock. We could easily solve this problem with sandpaper and sand down.

Substituting stirrer

If your console is broken, you have to find a replacement quickly. Any delay could destroy your clothes. Instead of an agitator, just remove the distributor who covers the stirrer and remove the screws to this title. After that, simply lift the agitator Out. While it is difficult to extract, fill the washer with hot water to remove any soap or something that keeps him down. If this system does not work, press gently on the shaker with a rubber mallet to free it. When the agitator is removed, you can replace it with another.